Bnc 7000 Series Programmer Manual Manual do Utilizador descarregar pdf (Página 32)

This command controls the LAN identify feature. ON(1) The command enables device identification by

displaying the full- screen message

"Identify: <IP Address>" on the signal generator's front panel; the LAN Status indicator will also show

"IDENTIFY". For more information, refer to the Programming Guide.

OFF(0) This command disables device identification by clearing the message on the signal generator's

front panel and returning the LAN Status indicator to display the

current network state. For more information, refer to the Programming Guide.

:LAN:IP

:SYSTem:COMMunicate:LAN:IP <ipstring>

:SYSTem:COMMunicate:LAN:IP?

This command sets the signal generator’s local area network (LAN) internet protocol (IP) address for

your IP network connection.

:LAN:KEEP:TIMeout (not implemented)

:SYSTem:COMMunicate:LAN:KEEP:TIMeout <value>

:SYSTem:COMMunicate:LAN:KEEP:TIMeout?

This command sets the length of time for the TCP Keep Alive setting.

Range 0 sec to 3600 sec

:LAN:RESTart

:SYSTem:COMMunicate:LAN:RESTart

This command restarts the network to enable changes that have been made to the LAN setup.

:LAN:SUBNet

:SYSTem:COMMunicate:LAN:SUBNet <ipstring>

:SYSTem:COMMunicate:LAN:SUBNet?

This command sets the signal generator’s local area network (LAN) subnet mask address for your

internet protocol (IP) network connection.

:SOCKet:ECHO

:SYSTem:COMMunicate:SOCKet:ECHO

This command turns the echo from the SERIES 7000 controller on or off. Echo is typically turned on

only for a telnet session. The SERIES 7000 returns a “>>” prompt when ready.

5.8

:TRIGger Subsystem

The trigger system is responsible for tasks such as detecting the start of a measurement cycle

(triggering) and enabling/disabling measurement for each measurement.

Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901

Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected]om, Web: www.berkeleynucleonics.com

1 2 ... 27 28 29 30 31 32 33 34 35 36 37

Sem comentários

Bnc 7000 Series Programmer Manual Manual do Utilizador Página 32