Bnc 1105 Universal Counter Manual do Utilizador descarregar pdf (Página 110)

110

110110

110

:CALC2:LIM:FCO

:CALC2:LIM:PCO

:CALC3:…

Note



The re-calculation is done automatically when any change is made to any of

the :CALCulate[1|2] commands when :CALC:IMM:AUTO is ON.

:CALCulate2:IMMediate:AUTO <Boolean>

Sets if the re-calculation will automatically be done whenever there’s any

change made to any of the :CALCulate[1|2] commands.

When it is set to OFF, the :CALCulate[1|2] command produces new results when

the command is executed, even when new data is not acquired. And this allows

the user to have the new results on the same current data right after new

configuration changes.

Return



An ASCII-encoded byte. 0 means OFF, and 1 means ON.

Notes



This will be set to OFF after the counter has been turned off or a remote interface

reset.



Affects all the recalculation command settings.



The only limit result that can be post-processed is :CALC2:LIM:FAIL?. The limit

counts (:CALC2:LIM:FCO and :CALC:LIM:PCO) reflect measurements that were

limit-tested at time of data acquisition.

:CALCulate2:LIMit:CLEar:AUTO <Boolean>

Sets if the limit test results to be cleared when an :INITiate[:IMMediate] or

an :INITiate:CONTiunuous ON command is encountered.

When it is set to OFF, only will the :CALC2:LIM:CLE[:IMM] command clear the limit

testing results.

Return



A single ASCII-encoded byte. 0 means OFF and 1 means ON.

Notes

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 196 197

Sem comentários

Bnc 1105 Universal Counter Manual do Utilizador Página 110